SharkSugender
I should Work at Oakley
- 3,622
- 1,823
I just remembered. Eye jacket lenses were a perfect for fit for R1 MJ frames!If there’s a place to ask for such a thing I would guess it would be here in this forum!
Last edited:
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: this_feature_currently_requires_accessing_site_using_safari
I just remembered. Eye jacket lenses were a perfect for fit for R1 MJ frames!If there’s a place to ask for such a thing I would guess it would be here in this forum!
Hello brother, how about using Romeo 1 BI lenses ( i mean cutting the ordinary black iridium R1 lenses because i heard that they are slightly bigger)? Thanks!I just remembered. Eye jacket lenses were a perfect for R1 MJ frames!
It's doable but aren't you scared the iridium might peel off when you remove the tape after CC them? They're pretty oldHello brother, how about using Romeo 1 BI lenses ( i mean cutting the ordinary black iridium R1 lenses because i heard that they are slightly bigger)? Thanks!
Bro, put a compared picture for the recordsBack to topic for those who have lower SN release, I noticed a small difference in my 0096 vs 7977...
I caught a glimpse while cleaning and noticed the bolt ends at the hinge are flat on the lower SN while tapered for the 7977 and are the same for the rest of my Romeos.
here you go.Bro, put a compared picture for the records
the one in the left is typical remnants due to thread rolling while you compared it to the one with a screw that was ground (maybe it was protruding out and the assembly guy just grind it off - I think screws cannot be a distinguishing factor for differentiation as batches of screws will have several flaws due to how it is being manufactured. I even saw screws without drive (torx/hex) or thread. This opinion though is purely based on what I have experience in assembly and machining technology.here you go.
0096 on the left, later 13xxxx on the right
View attachment 1004122
7977 on the left 0096 on the right:
View attachment 1004123
View attachment 1004124
View attachment 1004132
Have you measured 2 different R1 pieces (6 digit) they will probably display a variance with Casting process