A Fixer Upper Single Wide...need Some Help

[lu270bro]

Hey folks! I just picked up a single wide aluminum tower for pretty cheap, but needs a little work. I have the plexi shelves, but there are no shelf brackets to lay the shelves on. Is there any way someone can take a close up picture of the shelves, maybe underneath at the corners so I can get an idea of what I need to fabricate and how the shelf brackets are attached to the case? Any help would be much appreciated. Thanks

 

[Nortika]

It is a peg that sticks out that holds the shelf, I hope this helps

 

[lu270bro]

Hey man thanks for the pics. I will check them out when I vet home. Really appreciate it.

 

[David F]

If someone can confirm the black pegs are the same as used in the 3.0 then I have some extras. PM me and we can talk. Thanks.

 

[lu270bro]

That would be nice. I have to get some aluminum angle for the corners where it looks like a piece of angle holds the side plexi walls. I was looking at getting some round aluminum stock, cutting some pegs off, and soldering or welding the pegs on.

 

[David F]

Ok, so its not a threaded hole?

 

[xmetalmaniac]

Ok, so its not a threaded hole?

Its not threaded, its stamped into the angle aluminum and the top and bottom are notched to fit into the base and cap.

 

[David F]

Its not threaded, its stamped into the angle aluminum and the top and bottom are notched to fit into the base and cap.

And it would look like crap drilling and tapping a hole in the alum just for the peg.

 

[xmetalmaniac]

Its actually not part of the large rivet on the outside of the case...

 

[xmetalmaniac]

And it would look like crap drilling and tapping a hole in the alum just for the peg.

I dont think it would.....