Diy juliet nosebridge tightening

[Gjt777]

Hi I have sent a couple pairs of juliets to thexman to be tuned up but I have a pair that the nosebride is barely loose. Can I tighten this up myself? I can see that the pin is popping out very slightly on the loose side

 

Register to Not see this ad

[Wicked]

Not that simple.

 

[Gjt777]

Not that simple.

Is it possible? Common since would tell me to hold it tight and tap the pin in. That's why I wanted to ask first because I know my knowledge is very limited in this regard. I wouldn't mind investing time and money in tools considering this is a very common problem in juliets and I own 7 pairs.

 

[Wicked]

Remember an adjustable wrench isn't a multi tool

 

[Gjt777]

Remember an adjustable wrench isn't a multi tool

I am not sure where your going with this. I'm sensing your telling me it's a waste of my time?

 

[Zax]

Hit it with a nail punch 👍

 

[Jon the Don]

Hit it with a hammer 🔨

 

[Bonz-1]

Just leave it alone tell it needs a tune or send to me I can rub it back to health then return it to you down the road !! 😁

 

[ShortChangeHero]

Is it possible? Common since would tell me to hold it tight and tap the pin in. That's why I wanted to ask first because I know my knowledge is very limited in this regard. I wouldn't mind investing time and money in tools considering this is a very common problem in juliets and I own 7 pairs.

It’s very possible but if your not careful you can cause severe damage to the frame.

@SiRacer420 you still got the pic of the DYI bridge?

 

[Wicked]

I am not sure where your going with this. I'm sensing your telling me it's a waste of my time?

I'm telling you each tool has a specific job.