Half x orbital gasket?

[MicahS]

Can someone tell me if this is what a half x orbital gasket should look like. Not the obvious wear, just the general shape.

If so I plan on using this as a guide to cut some new ones since originals are unicorns.

 

[ZCForge]

I believe that looks correct however half x gaskets are thicker than others

 

[MicahS]

@zcrxsi Thanks. I'll take a caliper to this thing and see what the thickess is.

It came out of a half x but the nose bombs off it appeared to be from a half jacket and the earsocks were from a juliet so I wasn't sure if this was authentic or just something that was tossed in there to make due....lol

 

[ZCForge]

They should be about 1.25mm thick

 

[scienergy]

It's got a special shape and needs to be molded and not cut IMO.

 

[XM-I]

Anyone fabricating these?

 

[TheStig]

I would buy some as well.