My custom stuff (lens etching, 3d printing and vinyl)

[SiRacer420]

Looks great, you could make a sticker that fits over it to hide the stripes maybe

Possibly. But I dread the measurements that would require lol

 

[The_Darkone]

This one came out better. Still not sure about the design. I don’t like the stripes that are left near the rivits.

View attachment 481339 View attachment 481340 View attachment 481341

Perfect fit though.

View attachment 481342 View attachment 481343

Great job! Is the black circle printed as part of the stand or is that an insert for the coin?

 

[SiRacer420]

Great job! Is the black circle printed as part of the stand or is that an insert for the coin?

Thanks man. It’s two pieces. The black piece and then the silver is another and is glued on.

This is the black piece printing.

This is a scaled down version of the black piece. Messing around with pop cards.

They glow!

 

[Blondie]

Thanks man. It’s two pieces. The black piece and then the silver is another and is glued on.

This is the black piece printing.

View attachment 481410

This is a scaled down version of the black piece. Messing around with pop cards.

View attachment 481409

They glow!

View attachment 481408

OMG!! So cool!!


Sent from my iPhone using Tapatalk

 

[Nortika]

That black and glow on the dark XX is bad ass

 

[The_Darkone]

View attachment 480750
Thank you @SiRacer420! I love it!!!


Sent from my iPhone using Tapatalk

Hey @Blondie, do you mind sending the purple card holder back to me now. I was only loaning it out for a short time. Now it’s time to come home

On a serious not I may have to get some of mine colored as well.

 

[Wicked]

Hey @Blondie, do you mind sending the purple card holder back to me now. I was only loaning it out for a short time. Now it’s time to come home

On a serious not I may have to get some of mine colored as well.

Some may remember where those came from if they've been around for a long while.

 

[SiRacer420]

Some bag stands I finally got around to making. This is the third version and a 4.0 is printing now.

 

[Blondie]

Some bag stands I finally got around to making. This is the third version and a 4.0 is printing now.

View attachment 485795

Awesome! Might be a Blonde question... but how do they stand?


Sent from my iPhone using Tapatalk

 

[SiRacer420]

Awesome! Might be a Blonde question... but how do they stand?


Sent from my iPhone using Tapatalk

Nope, that’s a good question.

This one is 3 piece. A base, an inner plate and an outer plate. The plates have magnets (how the **** do they work?) to hold them together and the outter one has a tab to go in the base.

Observe!

The next one will be just 2 pieces with the base integrated into the outter plate.