"Twisted" frame help.......

[sevenfourate]

Hi 'guys',

Just had a pair of Holbrook XL's delivered this morning. Ripped off all the labels etc........then realised the frame is very slightly 'twisted'

Appears that what i need to do is heat (?) the bridge [Hot air, boiling water ???] and twist + set them in a square position so that both arms sit parallel with each other.

Any advice before i do something i'll regret............???

 

[glock24shooter]

Did the hair dryer method to a pair of dirty mos works great

 

[sevenfourate]

Did the hair dryer method to a pair of dirty mos works great

Thankyou ! Do i need to remove lenses first ? Or go careful with direct heat to just bridge; and lense removal not needed ?

 

[Broccoli]

Remove the lenses.

 

[sevenfourate]

Popped the lenses out; warmed the bridge with a hairdryer for 20 seconds, then gently supported but twisted them to sit squarely - and then quenched under the tap with cold water to hold that position. Popped the lenses back in and all good again in my World..... Thanks all.

 

[glock24shooter]

Outta boy!!!

 

[glock24shooter]

Thankyou ! Do i need to remove lenses first ? Or go careful with direct heat to just bridge; and lense removal not needed ?

LENSES OUT DAN!!!!!!!

 

[Tom.]

LENSES OUT DAN!!!!!!!

They’re little footballs!