Lens slightly too big help

[Slojack]

Custom lens I bought that is that close to closing.

Should I trim this side

Or this side

Bought these customs. Right lens fits fine, but this one is slightly too big. The left side or right side pics have a factory XX BIP lens over it. The differences on the sides are me sliding the lens flush left or flush right. There's no top or bottom difference, just left or right.

@Chris A Hardaway @xmetalmaniac
I know there's others that are versed in the ways of custom lenses, just brainfarting right now.

 

[QLR1]

@zwc0442

 

[zwc0442]

Just need to shave down the lens a little to get it to fit looks like. X metal orbitals vary a bit from frame to frame so they may have been fitted to another frame when the person cut them that had slightly bigger orbitals than your frame has.

 

[ShortChangeHero]

I have the same issue.

 

[Slojack]

Gonna do surgery tomorrow.

 

[Blockster]

If you have another set of lenses that fit that frame well, place the good lens on top of the lens that is too big and you will see which side needs trimming. Then when you are too scared to **** it up send it to @Chris A Hardaway and he'll do it for you for a reasonable fee...

 

[ShortChangeHero]

Gonna do surgery tomorrow.

Some pics or step by step would be much appreciated. I have sand paper and a dremel but too scared to take the leap and too cheap to send them out

 

[OakleyFrankFMJ]

Gonna do surgery tomorrow.

 

[Chris A Hardaway]

Too cheap to send photos, send me the lenses, and I'll trim for $20?

Have a pro do it
A little off both sides works best honestly, but depends on if one side looks further off than the other. Bevels look weird on them, don't they? Might just be bad lighting.

The side in picture three looks more off than pic #2.

 

[Slojack]

I'm calling it a success.
Shaved a micron more than I wanted, but it fits just fine.