midsy

Oakley Beginner
2
1
Hello,

I just purchased this Doublewide case.
624319


When I picked it up, all lighting was working correctly. After leaving the case fully lit for a while the top lights went out. I turned the case off for about an hour and when i turned it back on the lights worked again. Last night, again, the lights only on the top went out. I left the case off all night but they are still not working in the morning.

I tried to do a little trouble shooting but I'm no electrician. All the wires appear to be correct and i cant find anything wrong. The lights on the bottom have been working correctly. I've added a few pictures of the top.
IMG_20190609_104429.jpg
IMG_20190609_104416.jpg


Thank you for any advice that may help me ✌
 

Shade Station Oakley Sunglasses
Register to Not see this ad
Last edited:

Royal Commander

Oakley Beginner
Premium Member
I had some similar problems. I went to all led light bulbs noticed one of your lights doesnt appear to be LED. Should still work though. Take one light out that isnt LED and see how it runs. If that isnt it I would say power supply/transformer.
 

SiRacer420

BWPMF
Premium Member
Lifetime Member
10,713
2,993
NOLA
Sounds like the driver is dying. Replace it and go with all LED. I and some other members have documented the process. You’ll have to search to find them.
 

midsy

Oakley Beginner
2
1
The first pic you show, the lights on top are working. Are you talking about the light for the Oakley logo at the top?
The First picture was taken before the lights went out to show what it looked like before. Sorry, i realize i didn't make that clear at all. I didn't even notice that the Oakley light was out before, i thought they went out simultaneously
 

hondazcrxsi

Shelf Whore Extraordinaire
3,031
673
Amish Country, USA
The First picture was taken before the lights went out to show what it looked like before. Sorry, i realize i didn't make that clear at all. I didn't even notice that the Oakley light was out before, i thought they went out simultaneously
the Oakley logo is illuminated by the fluorescent tube at the top. If it doesn't turn on after you replace the tube, you probably have a bad ballast. It's very common on the 3.x towers.
 

New Threads

Top